I have an injector which is defective. The problem is: As I select a 150 ml syringe, a flow rate of 10 ml/sec and try to inject a volume less the 146 ml, the injector panel locks and a communications error message is lit at the front panel.
If I inject 150, 149, 148, 147 or 146 ml, the injector works fine.
I inquired about this service manual back in January, but didn't realize that there is a $10 charge for the Medrad service manual. I did find a hard copy though, so I opted not to purchase the electronic copy. Just an FYI.
Dear Alex, found you on dotmed. I need a service-manual too for Mark V provis. At my Unit i had a defective varistor V2 on relay-board. now the unit starts up normally (i think), i can program and if i start injection, the motor for syringe doesnt work in both sides. Without manual its difficult. Please con you help me? Thank you. holger
I have the same problem, the equipment starts up normality i can program and if i start injection, the motor for syringe doesnt work in both sides. I press enable and then press forward or reverse and the piston doesnt move.
Can you help me?
Please send me and e-mail: